TP-C812A, Measuring Lead for HandyProbe HP3

SKU: TP-C812A

Category: Measuring Instruments

GTIN: 7423634430464

Accessory and spare part for HP3
Differential measuring lead
very flexible, heat resistant silicone isolation
high common mode rejection

35,94 €

incl. 19% VAT , plus

Available
: 6 - 8 Workdays (DE - int. shipments may differ)

Available
: 6 - 8 Workdays (DE - int. shipments may differ)

TP-C812A, Measuring Lead for HandyProbe HP3

The Measuring lead TP-C812A is a low noise differential measuring lead designed to be used with the HandyProbe HS3. This 2m long measure lead splits in two individual ends of each 1.2m long. The dual banana socket connector at one end plugs directly on the European mains plug adapter that can be attached to the instrument. The two other ends each feature a single 4mm banana plug, on which application specific test points, clamps or probes can be plugged.

The Measuring lead TP-C812A is very flexible, uses a heat resistant silicone isolation and shrouded banana plugs.

The input of the Handyprobe HP3 is differential, which means that both sides of the input have a high impedance. There is no connection to ground as in conventional oscilloscopes which are used with coax cables. Using a coax cable on this instrument would result in the instrument picking up a lot of external interference.

High CMRR

The specially designed Measuring lead TP-C812C has a high Common Mode Rejection Ratio (CMRR), it is very insensitive to external interfering signals. The two ends can be placed up to more than two meters apart, while picking up very little interference. With a conventional oscilloscope with a standard oscilloscope probe this is not possible. The maximum distance between the positive side and ground is then usually limited to approximately 20cm. And this 20cm is very susceptible to interference. The Measuring lead TP-C812A for the Handyprobe HS3 does not have this disadvantage. External interference is very well suppressed by the special construction of the Measuring lead TP-C812A Measuring between two distant points is now possible.

Technical data:

Connectors:
Instrument side:	dual isolated 4mm banana sockets
Test point side:	red and black 4mm shrouded banana plugs
Bandwidth:	8MHz
Safety:	CAT III, 1000V, double isolated
Dimensions:
Total length:	2000mm
Length to split:	800mm
Length individual ends:	1200mm
Weight:	75g
Colour:	black
Certifications and compliances:
CE conformity:	yes
RoHS:	yes
Accessories
Colour coding rings:	5 x 3 rings, various colors